Posts Tagged ‘Canon cameras’
Many people have asked about repairing their front covers/flaps on their Canon PowerShot SD series cameras, so I’ve written up some instructions. Our lens barrier repair kit is a little tricky to replace on Canon SD series cameras but definately not impossible for you to do yourself. All you need is some patience, a steady hand and a small tipped screwdriver. We use dental picks, they work great!
To get things started, turn on the camera to extend the lens and then open the battery door and remove the battery so that the lens stays out. This allows you to easily work on the lens barrier assembly.
First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Some cameras don’t have one, so if there isn’t one in your kit then your camera doesn’t need it. Be certain that it will rotate slightly after installation, otherwise it is probably not installed properly and can cause the lens to get jammed.
Next are the springs and flaps. There is a small little tab that holds the spring in place when you put it on the ‘flap’ or ‘barrier plate’ as they are actually called. They are TINY, they are hard to hold and if you drop it… lets just say DON’T drop it on the carpet, ok? If you do lose some springs, we have them available on their own in our store for you to purchase.
Carefully put the cover or ‘flap’ in the hole with the spring pointing towards the post where the other end will connect, and then with something with a tiny and pointy tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.
Do this with the flaps in the open position, they will stay in place if you get them seated properly. If everything pops off, just start again. Try not to stretch out the springs, they need to remain tight for the assembly to work properly.
Then gently put on the barrier cover, it’s a flat plastic ring. There are tabs on the barrier cover, they match up with little slots on the lens and it locks into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.
Now it’s time to test your skills! Put in the battery (cross your fingers) and press the power button! Is it working? Did it go flying across the room with a cute little *SPROING!* and maybe all the parts scattered all over the place? Yeah I hope not, but I’ve been there myself so you’re not alone.
Once it’s working nicely …you’re almost done with your first digital camera repair!
Next put the dual sided tape on the barrier cover. CAUTION: Make sure to take the tape off of the backing paper but DON’T remove the paper that matches the shape of the tape on the other side!! Removing the small paper part will cause the tape to fold up on itself and stick together. Bye bye tape!
The tabs of the tape fold over the edges, if they stick out the lens cover will not fit properly and can jam up the lens. The tape lines up with one tab at about the 11 o’clock position, then fold the tabs over and press them in so they don’t stick out.
Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.
Fire up the camera again and admire your handywork! Congratulations you now know more about digital camera repair than the Geek Squad, and they told you it would be two hundred dollars and take 3-4 weeks to repair. Whatever Geek Squad… Whatever.
Hmm… I think I’m seeing the beginning of something big here; affordable do it yourself Canon digital camera repair